Licensed Maryland HVACR contractor · 41 years in Montgomery County 24/7 emergency service
Poteete HVAC · since 1985

Potomac, MD · Heating · 24/7 emergency

Heating & Furnace Repair Service in Potomac, MD

No-heat service across Potomac's large and complex heating systems

Local detail

Furnace Repair in Potomac

A no-heat call in a Potomac house frequently involves determining which of four heating systems has failed, and whether the fault is the equipment, the zoning, or a control layer that ties several systems together. Homes with radiant floor zones alongside forced air add another variable, since a radiant zone failing is slow and subtle rather than obvious — the floor simply stops being warm and the forced-air system quietly compensates.

  • Radiant floor zone failures present slowly and are usually a circulator, zone valve or mixing valve fault
  • Propane systems in Glen Hills need tank level and regulator pressure verified before diagnosing the appliance
  • Whole-house generators need to be verified as actually carrying the HVAC load — many are not sized for it
Condensing furnace anatomy A cutaway of a high-efficiency gas furnace showing the PVC intake and exhaust, inducer, burners, primary and secondary heat exchangers, blower, filter and condensate drain. Exhaust / intake Inducer draft Heated supply air Secondary HX Primary HX Gas valve ECM blower Filter / return Condensate
Current federal minimums put most new furnaces in the condensing class, which changes the installation more than the appliance: PVC venting instead of the chimney, a trapped and neutralised condensate drain, and a water heater that may be left orphaned in a flue sized for two appliances.

The housing

What we find in Potomac homes

Predominantly large single-family homes from the 1960s through the present, ranging from mid-century ranches on acre lots to 6,000–12,000 sq ft custom builds; substantial recent construction and gut renovation activity.

  • Three to five separate zoned forced-air systems in a single residence
  • Geothermal ground-source heat pumps with vertical or horizontal loop fields
  • Hydronic radiant floor heating, frequently in basements, baths and garages
  • Whole-house steam humidification and high-MERV or electronic air cleaners
  • Propane-fired equipment in Glen Hills and other areas without a gas main

Scope of the work

  • Full ignition sequence diagnosis: thermostat call, inducer, pressure switch, igniter, gas valve, flame sense
  • Carbon monoxide test in the flue and in the living space
  • Heat exchanger inspection, with camera documentation when a crack is suspected
  • Gas pressure verification at the manifold and inlet

Utilities · Potomac

Electric: Pepco. Gas: Washington Gas where mains exist; propane or oil in Glen Hills, Travilah and outer areas. Water: WSSC Water in served areas; private wells common in Glen Hills and outer Potomac. Permitting authority: Montgomery County Department of Permitting Services (DPS).

Neighborhoods covered

Potomac Village, Avenel, River Falls, Falconhurst, Glen Hills, Bedfordshire, Piney Meadows, Travilah, Potomac Falls, Normandy Farms Estates, Fox Hills and the surrounding 20854, 20859 ZIP codes.

Local factors

Conditions that shape this job in Potomac

  1. Private wells and water treatment

    Well water in the Potomac area commonly carries hardness, iron and sediment well above WSSC levels. Untreated, it will scale a tankless heat exchanger within a few years and consume a water heater anode rod rapidly. Any tankless or high-efficiency water heating installation here should be planned alongside treatment, and we say so before quoting rather than after the warranty claim.

  2. HOA and design review

    Avenel and several other Potomac communities operate architectural review with specific requirements for equipment screening, placement and visibility from common areas. Getting approval before installation is straightforward; getting forgiveness afterwards is not. We prepare the submission as part of the project.

Questions

Furnace Repair in Potomac — common questions

Our radiant floor stopped feeling warm but the house is still heated. Is it broken?
Probably a zone circulator, zone valve or mixing valve rather than the boiler, since the rest of the system is still working. Radiant failures hide well because the forced-air system compensates and the house stays at temperature. It is worth diagnosing rather than ignoring — a failed mixing valve can also send water hotter than the floor assembly is rated for.
My furnace blows cold air. Why?
The most common causes are a failed igniter or dirty flame sensor causing the burner to light and immediately drop out, a tripped high-limit from restricted airflow, or a thermostat set to FAN ON rather than AUTO, which runs the blower continuously between heating cycles. The last one is free to fix and worth checking first.

More furnace repair questions answered on the Maryland service page →

Talk to a technician

Furnace Repair in Potomac? Tell us what the system is doing.

Describe the problem and we will tell you what it usually means, what it typically costs to diagnose, and when we can be there. No obligation, no scripted sales call.

Call (301) 555-0182 Request a quote

Mon–Fri 7:00am–6:00pm · Saturday 8:00am–2:00pm · 24/7 emergency service